I’m selling my beloved Yota after ten years, this truck was my daily for about five years until the 3.
0 died on me, swapped a 3.
4 this last December and I am extremely happy with it, it’s just too small for what I want it for.
Below is all the engine work I had done professionally at Toy Only Swaps.
It’s also had an add a leaf kit installed, and brand new 30” All Terrains with new rims.
Replaced the diff, transmission and transfer case fluids about 1,000 miles ago.
Complete 3.
4 swap/conversion MT Air pump and Toyota timing belt, idler bearings and tensioner
New factory Toyota thermostat & Gasket
New Bando Alternator, ac, Power steering belt
New factory Toyota spark and spark plugs
Rear main seal replacement with Factory Toyota Seal installed Factory Toyota Front main seal replacement
Factory Toyota Cam seals
New factory Toyota valve cover gaskets, spark plug seals, and rear cam caps vapor hone cleaning of valve covers included
New Denso Front and rear 02 sensors
New Toyota PCV Valve and Grommet installed
3.
4 swap Toyota/Aisin OEM clutch kit with new flywheel
Option#3- Low profile upper and middle intake plenums
New OEM Clutch hose from firewall to cylinder head, original was near failure, bleed clutch system
Rubber exhaust hangers x2 needed to support exhaust
Build 2 J exhaust hangers Needed to support exhaust near catalytic convertor
Good used front exhaust heat shield original was missing Champion cc50 radiator
mechanical sim
New interstate premium battery
Truck has some small dents here and there, and I removed the rear bumper and front Valance planning to replace but I just haven’t had the time yet.
Lemme know by email if you’re interested.